Use the paint bucket shredder to do these to extend the service life

  Doing a good job in equipment maintenance can reduce equipment wear and tear, improve equipment integrity and utilization, reduce equipment operation and maintenance costs, and ensure safety. We can do this for the paint bucket shredder to extend its service life.

   1. Installation of equipment

   To ensure the smooth operation of the paint bucket shredder, the grounding must be tightened during installation to ensure that the equipment does not become loose. Tight installation can ensure that the equipment remains stable during long-term operation, reduces vibration and noise, and can also avoid damage to the equipment. This factor has a greater impact on the equipment than we think, so we must pay special attention during installation.

   2. Equipment operation process

   After the paint bucket shredder is started, do not rush to put in the materials. Make sure that the equipment is running normally before putting in the materials. During the re-feeding process, pay attention to feeding materials evenly and do not put too much material in at one time to avoid jamming. If material jamming occurs due to loading materials too quickly, the paint bucket shredder must be shut down in time, the materials must be cleaned, and the machine can be turned on again after cleaning.

   3. The equipment ends operation

   After the paint bucket shredder is finished running, make sure the material is completely discharged before turning off the power. After shutting down, pay attention to cleaning the crushing chamber, and promptly check whether the fasteners are loose and whether the blades are worn, and sharpen or replace the worn blades in a timely manner.

What are the key points that need to be paid attention to during the operation of the metal shredder?

The metal shredder has the characteristics of low speed, large torque, low noise, etc. There are many things that we need to pay attention to when we operate the metal shredder. Let’s take a look at the key points that need to be paid attention to. .

   1. First of all, turn on the machine and preheat it before working, observe whether the equipment is operating normally and whether there are any abnormal sounds, and then start feeding after everything is normal;

   2. When feeding, the material must be fed evenly, not fast and slow, too much and sometimes too little, and when feeding, it must be small first and then large, so as not to exceed the load that the motor can bear right after starting.

   3. If any noise or vibration is found, stop the machine immediately for inspection, and continue working after the fault is eliminated.

   4. When shutting down, you can idle it for two minutes and wait until all the materials are discharged before shutting down. This operation can not only improve the production efficiency of the metal shredder, but also effectively increase the service life of the equipment.